PDH Engineer     PE PDH
PDH Online

Preventive Maintenance Program


Quiz Questions

1. The purpose of preventive maintenance program in a building is to reduce the number of services orders to a point where buildings and structures are being maintained by scheduled work as much as possible.
True
False
2. Planning a preventive maintenance program is most effective when the work is accomplished on a cyclic basis.
True
False
3.

Cyclic preventive maintenance should be accomplished according to the following priorities:

 (a) Priority 1: Family Quarters

 (b) Priority 2: Other permanent facilities

 (c) Priority 3: Temporary Facilities

True
False
4. To insure the manpower requirements for preventive maintenance are accurately identified and properly documented which one of the following procedures should be followed.
Calculation of standard hours
Hours for between-occupancy preventive maintenance of family housing units.
Determination of manpower requirements for off-post facilities
Calculation of required manpower for each preventive maintenance area per cycle
Preparation of an individual job order for preventive maintenance areas
Automatic costing of preventive maintenance under I.F.S
All of the above
5. One principal for a successful preventive maintenance program is to minimize documentation, but still fully document preventive maintenance.
True
False
6. Preventive Maintenance cycles should generate fewer Service Orders as the work becomes systematized and long- standing maintenance requirements are reduced.
True
False
7. Preventive maintenance is most effective when the work is accomplished on a cyclic basis.
True
False
8. Buildings and structures with similar maintenance requirements should be located in common areas, unless other factors such as travel distance would make establishment of the area inadvisable.
True
False
9. In order to complete the scheduled cycle within a reasonable time frame, PM ( preventive maintenance) units should not undertake any maintenance or repair tasks beyond their capability.
True
False
10. The recommended length of an effective PM (preventive maintenance) cycle is between _____________________.
40 and 80 days
90 and 150 days
90 and 180 days

DiscountPDH.com

DiscountPDH provides the best and highest quality online PDH engineering continuing education to PE Engineers.

We provide live PDH webinars and live PDH seminars. They are also accepted for PE Professional Engineering license renewal with the State Board of professional Engineers. Our PDH Courses are accepted in all state of United States of America. These states are Alabama, Alaska, Arkansas, Connecticut, District of Columbia, Florida, Georgia, Idaho, Illinois, Indiana, Iowa, Kansas, Kentucky, Louisiana, Maine, Maryland, Michigan, Minnesota, Mississippi, Missouri, Montana, Nebraska, Nevada, New Hampshire, New Jersey, New Mexico, New York, North Carolina, North Dakota, Ohio, Oklahoma, Oregon, Pennsylvania, South Carolina, South Dakota, Tennessee, Texas, Utah, Virginia, Washington, West Virginia, Wisconsin, and Wyoming.

Engineering Continuing Education PDH Courses
ALL PDH Courses
HVAC
ADA Accessible Design Courses
PE Civil Engineers
PE Structural Engineers
PE Mechanical Engineers
PE Environmental Engineers
PE Electrical Engineers
PE Chemical & Oil & Gas Engineers
PE Ohio Engineers
PE Nebraska Engineers & Architects
PE Illinois Engineers
Online PDH Courses
Land Surveying
Construction
Architecture
LEED - Green Building
Safety and Failure Analysis
Geology
Landscape Architecture
Building Inspection
Ethics & Law
Business Skills
Interior Design
Discount Packages