PDH Engineer     PE PDH
PDH Online

Blowout Prevention (Section 1)


Quiz Questions

1. A complete BOPE classification (e.g., Class III B 3M) is composed of three elements that identify, respectively, the division’s requirements for blowout prevention equipment, hole-fluid monitoring equipment, and rated working pressure of the weakest component of the wellhead stack and choke system.
True
False
2. The stack arrangements, depicted in Figures 1 through 6 of this section, are for illustrative purposes only. The operator may use any desired arrangement of preventers and drilling spools, provided the total system meets the BOPE classification assigned by the division and provisions have been made to control the well under any predictable conditions.
True
False
3. A Class I BOPE system consists of, as a minimum, any device installed at the surface that is capable of complete closure of the well bore with the pipe out of the hole. The device must be closed whenever the well is unattended.
True
False
4. Figure 1 is an example of a:
BOP stack class I
BOP stack class II
BOP stack class III
BOP stack class IV
5. Figure 2 is an example of a:
BOP stack class I
BOP stack class II
BOP stack class III
BOP stack class IV
6. Figure 5 is an example of a:
BOP stack class I
BOP stack class II
BOP stack class III
BOP stack class IV
7. An operator proposes to sidetrack a bad liner in a well located in a residential area. There are no flowing wells in the field. The zone pressure is 800 psi and the oil gravity is 19o API. The depth to the top of the zone is 3,600 feet. What class of equipment should be used?

Solution to the above could be:

Well Conditions

Proposed well operations: Redrill-development

Well environment: Onshore critical
Anticipated surface pressure: Medium pressure

From Table 1: Class III B equipment should be used.

True
False
DiscountPDH.com

DiscountPDH provides the best and highest quality online PDH engineering continuing education to PE Engineers.

We provide live PDH webinars and live PDH seminars. They are also accepted for PE Professional Engineering license renewal with the State Board of professional Engineers. Our PDH Courses are accepted in all state of United States of America. These states are Alabama, Alaska, Arkansas, Connecticut, District of Columbia, Florida, Georgia, Idaho, Illinois, Indiana, Iowa, Kansas, Kentucky, Louisiana, Maine, Maryland, Michigan, Minnesota, Mississippi, Missouri, Montana, Nebraska, Nevada, New Hampshire, New Jersey, New Mexico, New York, North Carolina, North Dakota, Ohio, Oklahoma, Oregon, Pennsylvania, South Carolina, South Dakota, Tennessee, Texas, Utah, Virginia, Washington, West Virginia, Wisconsin, and Wyoming.

Engineering Continuing Education PDH Courses
ALL PDH Courses
HVAC
ADA Accessible Design Courses
PE Civil Engineers
PE Structural Engineers
PE Mechanical Engineers
PE Environmental Engineers
PE Electrical Engineers
PE Chemical & Oil & Gas Engineers
PE Ohio Engineers
PE Nebraska Engineers & Architects
PE Illinois Engineers
Online PDH Courses
Land Surveying
Construction
Architecture
LEED - Green Building
Safety and Failure Analysis
Geology
Landscape Architecture
Building Inspection
Ethics & Law
Business Skills
Interior Design
Discount Packages